Description

Tactile Pushbutton Switch Module

This Momentary Tactile Push Button Module DC 5V Switch is ideally suited to add a button to your projects and gives a high signal when it is pressed. The module of the push button is a fully-fledged device with which you can install it immediately in the project, without using a pull-up or tightening resistances, because this is already in the circuit. The button together with the resistor is located on the board, where there are holes for installation. The built-in resistor has a rating of 10 kΩ.

Features/Specs:

• Operating Voltage: 3.3~5V
• Contact Resistance: ≤50 MΩ max
• Electrically Life:100,000 cycles
• Environment temperature: -25’C+105’C
• Operating Force: 180/230(±20gf)
• Seal temperature: 250ºC-280ºC
• I/O pins: 3 pins
• PCB thickness: 1.5 mm
• Length: 20 mm
• Width: 16 mm
• Height: 7 mm